KAL 20-D2RS
KA-D2RS: Rod ends , male thread, maintenance free, sealed
CAD-Model
You are welcome to look at this series of measurements from all sides with our interactive CAD model.
Specification
Identification numbers

101597

Measurement

18

M20x1,5

32

18

24,5

51

78

45

103,5

42

80

10

0,46

KA-D2RS: Rod ends, male thread, maintenance free, sealed

Special version

Plain bearing

2RS-Sealing

Maintenance free steel/PTFE

Female left hand thread

Standard

Inner ring: Antifriction bearing steel, hardened, ground, polished.

Outer ring: Brass lined with an antifriction film, consisting of PTFE, cold formed around the inner ring, outside diameter with thread, screwed into housing and secured with the rubber bellows.

Rubber bellows: Synthetic rubber with vulcanized brass slip ring and steel locknut.  

Housing: tempering steel (standardized), galvanized and chromated.

Bushings: Tempering steel, hardened, bore and outside diameter ground, pressed into the inner ring. They are only used as intake of the brass abrasive rings of the rubber bellows. Due to their low thickness they are not dedicated to transmit radial and axial forces into the spherical bearing.

Tolerances: To DIN ISO 12440-4, schedule K, except: d = H8, B = +- 0,3

Note: With these rod ends, it is important to ensure that the tilt angle specified in the table is not exceeded, either while mounting or during operation, otherwise the rubber bellows may be damaged.